Type 1 Teplo Tie.
For cavities of between 50mm-200mm.
Light duty wall tie suitable for box form domestic dwellings with a maximum height of 10m and leaves of a similar thickness.For flat sites in towns and cities where the basic wind speed does not exceed 25m/s and altitude is not more than 150m above sea level.
For walls in which both leaves are 90mm or thicker, 2.5 ties per square metre (900mm horizontal x 450mm vertical centres) should be used. For walls in which either leaf is thinner than 90 mm, 4.9 ties per square metre (450mm horizontal x 450mm vertical centres) should be used. At vertical edges of an opening, unreturned or unbonded edges, and vertical expansion joints, additional ties should be used at a rate of one per 300mm height, located not more than 225mm from the edge. TeploTie should be pressed down into fresh mortar and should be buried in to the fresh mortar to ensure that the tie is covered within the mortar joint. Ties should be installed with a slight fall to the outer leaf, not towards the inner leaf as this could provide a path for moisture to cross the cavity. The drip part of the tie should be positioned near the centre of the open cavity. Installed ties should be clear of mortar droppings to allow the drip to function and prevent water from crossing to the inner leaf of masonry. Insulation retaining clips are available for partial fill cavity walls.